A life-sized robothead of the robot Chappie from the movie Chappie. This is a big project and still in progress as im installing electronics too. Please share a photo if you make one.update 30/11-15 Added photos of Arduino support for the eyes.I started designing Chappies head with only a few photos before the movie was released. I use the free 123D design for designing all parts. It is not movie accurate, but im still satisfied with the overall look as it is now. The antenna-ears, the monobrow and the chin protection can all move by hand. All is printed in gray ABS 0,2mm layer and using Simplify3D and my Creatr dual from Leapfrog.