Make your mark!I included all the files created in the process. I started out using Gimp for the initial design, then saved that to svg and did the rest of the work in inkscape. In retrospect, I think I made this a lot harder than it needed to be, especially considering that the open source hardware logo comes in SCAD format.I got the RepRap teardrop from here: http://reprap.org/wiki/RepRapLogo and the open hardware logo from here: http://oshwlogo.com/ I'm not sure what the license is on these, so I just used a generic creative commons license.I marked both 3D printer and Laser cutter as required tools because I assume it can be done with either. I don't have access to a laser cutter so I can't say for sure.