A case for the http://reprap.org/wiki/RAMPS1.3 board. Used here to drive a small milling machine with pyCAM/FiveD/ReplicatorG toolpath. It is a tight fit that does not leave much room for ventilation so take care that the drivers do not run too hot.The case was printed, with raft, on a RepRap. The covers are both printed on a Makerbot with heated build platform. Things TODO: the board has a tight slidefit (is this proper english?) so be careful not to break the reset switch; USB connector hole has to be shifted a few mm upward; Use a drill to make room for the lower (Arduino Mega) board in the cover, see picture; Optionally drill a small hole for reset switch (paperclip) access.