I started with AprilStorm's Comm Pad and reworked it just a bit. I separated the buttons so it can be printed for the the dark or light side of the force. I compared this to the current resin version that 501st peeps are using and figure this is an improvement in all ways. Cleaner, color is more even etc. Easy to add hollows for electronics if needed. The Rebel version prints as one piece in white. The Tie Fighter version is a lil trickier. You can print in black and give gray paint job or vice-a-versa. Printed easily on a Rep2 or Rep2x. Med settings .20mm layer height using Makerware. I created custom supports that snap away easily after printing. Rebel Version 2x - But1 - Blue 2x - But2 - White 1x - But3 - Blue 4x - But4 - 3 Blue / 1 Red 1x - But5 - Black Tie Fighter Version 2x - But1 - Red 2x - But2 - Red 1x - But3 - White 4x - But4 - 2 Black / 1 Red / 1 White 1x - But5 - Gray Note: I did make a dual extrusion version to print the black/gray in one piece but isn't the cleanest result - the areas where the colors meet isn't as sharp as I like even with a well tuned machine.