I needed a combination cable clip and probe holder for a Craftsman Multimeter 82140.After a couple of prints, I added some mouse ears to reduce base layer warping and that seemed to help.When it was finished, I realized that the cable clip doubled as a nice little stand - a 'twofer'.The OpenSCAD design is very simple, so it is easy to modify for other multimeters.You just have to remove the mouse ears after printing.I could make the whole clip design longer and flatter and then have the cord reels go from top to bottom rather than side-by-side under the probe clips, but then the design wouldn't double as a stand.Suggestions for improvements welcome.