This will be 3D printed near you and delivered to your door by May 02
Loading
Hexacopter build. wood and printed parts with printrbot simple.Print all parts... one of each accept the motor mounts you'll need 6 of those and the landing gear, 6 of each side (leg 1 and 2)
parts designed around 15mm pine that you will need aprox 4.5m of or 3x1.5 Cut wood for arms to a length of 45 cm and place in bottom coupling. drill holes trough the wooden arms using the bottom coupling as a guide. use 3mmx20mm nut screws to affix the top coupling to the bottom. Motor mounts x 6.
use small self-tapper screws at the narrow part of the mount to fix the mount to the arm. dril holes trough the wood using the mount as a guide. Place the motor on the mount and tighten it down by screwing a 3mmx18mm screw from the bottom of the wood, trough the "mount" and into the motor.