Yea, I know I'm a bit late for the spirit of the holidays, but here's a reindeer cable wrap for your iPhone or iPad. The base is measured perfectly for the Apple charger. I tested on both the old iPhone cables and the new ones, works for both. Once you pass the USB cable through and plug it into the charging base, this thingy stays on without any help. I've demonstrated that with one of my pictures where I'm holding it by just one antler. It would be great if someone paints it and uploads their makes. Would love to see them :-DUnfortunately, the thing needs to be printed in 3 pieces. No supports are needed. Print the face at .1 mm resolution, and the others can be printed in .2 mm resolution. The whole thing took about 50 min total on my Replicator 2. After you're done printing, the face and antlers are inserted into the base. It's pretty straightforward to understand. I included the model of the whole piece so you can see how it looks when it's done. You can even potentially use this model on a floating UV cured liquid resin printer if you have one. You can use superglue to hold everything in place, however when I printed it and slipped the parts into their slots, I could no longer take them out anymore. The face, I could slip out with some pressure, but the antlers were impossible to take out once I put them in. So in other words, I really don't think you need superglue.