Alternative Name: "Office-ial" TF2 Dispenser Based on Riddellikins model, but modified to fit small 1.5x2" Post-Its, two pens, and paperclips (in the bottom). The Post-Its do require some double sided tape to stay in place (I suggest using poster tape, I got mine from Staples) and a small compression spring (got mine off amazon). Update: Finally got around to painting it. I used Plasti-Dip for the base coats and then Testor's model paint for the details. The "Provisions" sign was obtained from a papercraft website on the link below. Just scale it down to 50% and print on some paper. "Provisions" Sign source: http://extrafuture.com/2011/05/13/team-fortress-2-papercraft-dispenser/Materials: PLA, Compression Spring, double sided "poster" tape. See photos for how to install back plate and spring. If you properly size the hole around your spring no adhesive is needed to hold it in place. Might be easier to tape Post-Its to back plate before installing the back plate. Hot glue was used as the adhesive.