Yet another power supply switch holdery thingamabob. This one is: Parametric (scad), Vita-mina-metric (no screws required), Mini-malistic (slimline, so sits flat on surfaces etc.) Why its fused lighting!! http://www.altronics.com.au/index.asp?area=item&id=P8341 is the part used from altronics australiameasured the switch, measured the psu, scripted it up in scad, so adjustments are easy for you all, printed it out, wired up switch and crimped up connectors, then pushed together (no screws required!)I have revised (V2) design that now incorporates side switch and exit for power cable. This means that it will sit vertically behind the i3, and "tuck away" behind the printer, with a "regular" plug and switch to the right, and power exit to the left towards the ramps.I will post another picture soon with placement on the i3.