Like Nespresso coffee but fed up with having capsules everywhere? Think the commercial capsule holders are far too expensive?This thing is a parametric Nespresso coffee capsule holder, so you can make a holder for as many capsules as you like (limited by the size of your build table!)The capsules are dropped in from the top of each row, and are removed with a simple pull and lift movement from the bottom. Please note: This is NOT endorsed by Nespresso.Print, affix to wall/cupboard door.Load with 5 capsules. Enjoy.You can print multiple holders and fit them side by side to make a Nespresso 'wall' - the 'cover' picture shows 5 of the 'x5' holders, each glued together with epoxy, then glued to the tiled wall. Caffeine-tastic!The files are as follows:capsule-holderx5.stl - A 5 capsule nespresso holder. This just fits on the build platform of my Reprappro Mendel. (it actually JUST holds 6 capsules due to the way the capsules sit). My photos use this model.capsule-holderx3.stl - A 3 capsule nespresso holder, for those with smaller build platforms.capsule-extensionx2.stl - A 2-capsule extension piece, which together with the above will give you a 5 holder nespresso thing.Build tip: I found I needed to have a 60'C heated bed in order to prevent the corners peeling up - at 50'C, it tended to lift!