A bust of a devil. Modeled in SculptrisI made it with 3 shells 0% infill No support was needed. a few small top of the model holes near the horns. I filled them in with ABS/acetone goop (white glue viscosity) print and paint. I suggest making the skin red. use for whatever evil purposes you desire. notes on how i finished(painted) i did a little experiment finishing ths piece, i made a thinner abs/acetone mix (almost like latex paint viscosity) and used a paintbrush to paint the model. I followed up with acetone on the brush to smooth the spots which needed it. the result was a very smooth model with minimal layering apparent. (this did give that milky white coloring but i was going to paint anyhow) i used craft acrylic paints and a artist brush to paint it up. A clear enamel spray for the shiny finish.