This will be re-uploaded to another site once a suitible site is found. I do not believe that I, or the original author (in the case of my derived works) appreciates giving up all rights to own our own designs. Once A suitible location is found, or a temporary one is located, A note will be posted here. Have fun! Download link: http://randmsystems.com/Media/printer/catapult_accessories_b.stl These are accessories and add-ons to the Seej Catapult. In the combined file, half are from other people, sources attributed. The accessories are as follows: Standing Legs Attachment - As anyone who's printed the catapult notices, the arm hits the ground and may throw aim off a bit. These are just printed out and snapped on the bottom to give it a little bit more height. They can be removed (front or back) to adjust aim a little. Standard Arm: I like to print this as part of the kit, along with another thing which will be posted later. It just feels incomplete without this. Cup-arm: Wauter made this rather nice cup, and I like it as part of the accessory kit I use. Horizontal-Arm: While play-testing Seej, a few of players insisted on trying to use the standard arm to launch a penny sideways, for more surface area. This was created as an answer to that. Two pennies can be fitted into it's shaped-bucket. Delux Tripple-Arm: Mattbstrong made this one as part of a delux catapult. While the arm is a bit tight for pennies (Does a good job with dimes), it's too cool to exclude. The round-bucket cup is from the Seej Catapult Mod by Wauter at http://www.thingiverse.com/thing:24074The 3-penny launcher is from the SEEJ Deluxe Penny Catapult by Mattbstrong at http://www.thingiverse.com/thing:27775The single-launcher is from the stock Seej.The standing legs are original.The dual-penny horizontal penny launcher is original (Although was by request)