v1.1 - last updated 4/29/14 This is a remix of Serin117's "MA5C ICWS - Assault rifle - Halo 3" found at: http://www.thingiverse.com/thing:169170 I cut the original model into easily printed pieces with pins so it would fit on the build plate and you don't have to mess around with perfectly aligning everything. All female pins are slightly wider/deeper than their male counterparts, so they should fit fine. The OpenSCAD library/files used to generate this can be found at: http://www.thingiverse.com/thing:310652 Have Fun!v1.1 update changes: -increased female pin margins for a better fit, if you've already printed one of the parts with pin holes, you should still be fine with a little sanding -uploaded a standalone female pin, reccomend printing the stock first along with the pin, if it fits, continue on, otherwise you may need to update the radiusMarginin PinCutDemo2 - Halo AR.scad (v1.1 is .5 by default). All files can be found in the zip containing the library at: http://www.thingiverse.com/thing:310652 Some things to note: -If you scale any of the pieces, you need to scale them all by the same factor. -If you print with supports, you might need to clean out the female pin holes (depending on orientation), but that will probably just amount to sticking a drill in it or sanding off the male pins. -You will probably still want to DAP/glue the pieces together, as the pins will not be completely solid, they might be prone to bending.