So this is a case for the Bus Pirate v3 board from Seeed Studio found at http://www.seeedstudio.com/depot/bus-pirate-v3-assembled-p-609.html?cPath=61_68v3 is much smaller than then v2 board that is found here.Mods for the future are better accessibility to visualize the surface mount LEDsI also included the Sketchup File that I am using for any modifications. Hope someone can enjoy it as much as I did.This is a derivative of the following Bus Pirate v2 cases http://dev.thingiverse.com/thing:1716 http://www.thingiverse.com/thing:2135Print, place board in case. Seems to be that if you place the probe set on before the top you have an easier fit. Then place four screws or bolts through the holes and you are ready.