Discontinued - see http://www.thingiverse.com/thing:454791 instead. 2 axis gimbal for DJI Phantom 2 Vision (non plus) for FC200 camera. This is how I do my testing: http://youtu.be/ApPEFi2EdyM 27/6/2014: To complete this build, you will also need: 1x Basecam 2 axis controller board with IMU 2x Turnigy 2206-140Kv gimbal motors 8x M3x8 hex screws 8x M2x6 hex screws 8x M2 (4.8x0.3mm) washers (ADDED 22/6/2014) 6x M3x20 nylon screws 1x M3x16 screw 1x M3 nut 1x 3.5mm female 4 pole jack 1x 3.5mm male 4 pole jack with wires (90 degree angle) 1x 50mm 1 pin wire (pitch control) 4x "red" (300g) dampeners Mad soldering skills FC200 specific: 1x M3x16 screw 1x M3 nut GoPro Hero 3(+) specific: 2x M3x16 screw 2x M3 nut Plastic tubing to protect exposed FC200 jack (Next rev: additional 4x M3x16 screws, 4x M3 nuts - dampeners)