MotorPixie 2D Gimbal, adjusted for parts from the "popular" GoodLuckBuy gimbal. LD-POWER 2212 Gimbal motors and alternative controller board. Should also fit the much more powerful Turnigy HD 2212 Brushless Gimbal Motor (BLDC) (http://hobbyking.com/hobbyking/store/__45365__Turnigy_HD_2212_Brushless_Gimbal_Motor_BLDC_.html) If you are looking to build one from scratch, PLEASE use the version for Turnigy motors and BaseCam controller board instead! http://www.thingiverse.com/thing:363690 27/6/2014: To complete this build, you will also need: 1x GoodLuckBuy controller board with IMU 2x LD-POWER 2212 Gimbal motors 8x M3x8 hex screws 6x M2x8 hex screws 6x M2 (4.8x0.3mm) washers (ADDED 22/6/2014) 6x M3x10 nylon screws 1x M3x16 screw 1x M3 nut 1x 3.5mm female 4 pole jack 1x 3.5mm male 4 pole jack with wires 1x 50mm 1 pin wire (pitch control) 4x GoodLuckBuy dampeners Mad soldering skills FC200 specific: 1x M3x16 screw 1x M3 nut GoPro Hero 3(+) specific: 2x M3x16 screw 2x M3 nut Plastic tubing to protect exposed FC200 jack (Next rev: additional 4x M3x16 screws, 4x M3 nuts - dampeners)