This is a remix of "halo 4 helmet full size A". It is sliced so it can be printed by an UP! mini printer. !NOTE! The instructions on this page are important, and you will still need to download parts from big red frogs page. Also I did not create these files or add to them, I merely sliced them so they would fit in my printer I take no credit.You will need to mirror some of these files, this should not be a problem if you are using PP3DP slicing software. If you are unable to please let me know. I will try to make this as clear as possible. The best way to prevent the parts from warping is to print them at a moderate angle. So for instance if a part has flat joining faces print it at an angle off the print bed. Part list copy_of_rgg1.stl copy_of_rgg1.stl mirrored polysoup.stl polysoup.stl mirrored polysoup-4.stl polysoup-4.stl mirrored polysoup-5.stl polysoup-5.stl mirrored peak.stl peak.stl mirrored peak_tip.stl peak_tip.stl mirrored polysoup-2.stl polysoup-3.stl These following parts will need to be downloaded from http://www.thingiverse.com/thing:158120/#files Back Bottom Rear Bottom (left and right files) Back Fan Rear Top (left and right files) Temple (left and right files) Chin (left and right files) Insert (left and right files) Back Fan Insert Chin Front Visor Full (left and right files, do not use the single part stl it will not fit) Some of the files will need to be oriented at odd angles to fit but with patience they will fit. The parts will need to be joined with an epoxy or PVC cement and the gaps filled and then sanded. Pins to temporarily hold the larger parts together can be found at http://www.thingiverse.com/thing:260333. If you are going to paint it be sure to sand all the showing plastic to reduce the layer ridges and give the paint some adherence then prime. If you want it to look worn after the primer, spray 2-3 good coats of mat silver then 2 coats of your choice color. Once the final coat has dried over night, sand through on some of the ridges and as the muse direct. Good luck!