This is a compact stand for the Wii U Controller which can be used as a small screen with the standard controls. The stand may not be pretty but it gets the job done. Enjoy! The only place where glue is needed is for the "pins" at the bottom and the top of the back brace. CrazyGlue works great for this job. The detents for locating the pins on the front "L" brace are slight. The pins aren't intended to fit inside they are only to help to center them. Just glue them on. The back braces have pins which fit very snuggly and help locate the back pieces. The top of the back braces should be glued to the bar it lines up with. The other fittings are intentionally tight and may need a little 220 sandpaper to fit into place. The .skp file is provided to make changes.