For holding and counting Chilean coins. Para organizar y cuentar monedas Chilenos.Warning: this model is taller than 100mm. You may encounter bad mojo if your printer cannot print higher than 100mm.The design was made for reprap, so I had to enlarge the small coin tubes to fit properly. Higher-res printers may print the holes too big but the coins should still not fall out. Each tube should hold 50 of each coin. Built in 3dsMax.Imprimir y disfrutar :) Hecho para Reprap, puede ser que los tubos de las monedas chicas son un poco grande. Entonces, cada tubo tienen capacidad para 50 monedas de cada tipo.