This thing was made with Tinkercad. Protect your nanotech camera, make a paramedic jump kit for a mouse, wear it on a chain like a modern locket. Have not printed this yet - I am still awaiting the shipment of my Printrbot. Please let me know how it comes out when you print it! OR buy one from these guys: http://www.shapeways.com/model/867397/hinged-mini-pelican-case.html The photographs are Shapeways' "Black Strong and Flexible". It prints very well in laser-sintered nylon. ATTENTION This work is licensed under the Creative Commons - Attribution - Non-Commercial license. This license applies only to the files and documents available for download from the Thing Files section of this Thing. All other related content (photographs, videos, and verbiage such as contained in "Description" or "Instructions" ) are excluded from this license. with all rights reserved, unless specifically available for download This notice constitutes a clarification, not a change, to licensing for this design. There is no tolerance in the joint of this two-piece Thing. The hinge assumes perfect precision. If they bind you may need to adjust one side or the other to get a better fit. Please give me any feedback about how it fits together when you print it, including printer used and layer resolution, if known. Thanks!