Update: Now check out FlexMesh 2.0 which takes FlexMesh to the next level. FlexMesh suggests a few interesting ways to think outside the box when designing for today's 3D printers. Updates... Makerbot slicers are now supported for single-layer meshes. Makerbot and Simplify3D slicers has been successfully used to print these shapes. All prints have only been done using ABS on FlashForge printers with a layer height of 0.2mm, 2 shells and a 10% infill. The longest length mesh printed so far is about 8.5 feet. (This 147mm tall print consumed almost 2kg of filament and took a FlashForge Creator X 200 hours to complete.) Filaments used to produce flexible and durable joints include Octave and Zen Toolworks. Simple dimensional drawings have been uploaded that show the individual shapes of the mesh as well as the dimensions of various useful shape combinations. The mesh was intentionally designed for easy manipulation. All the flat shapes are 6.75mm tall. Both the large and small shapes (which are called 'main' and 'sub', respectively) repeat every 25mm in both the X and Y dimensions. Successive vertical layers of fabric are always 7mm above the layer below. The 'short sub' shape (which is 14mm tall) is used to connect Main objects of adjacent layers. Single layer meshes are printed without a raft or supports. However multi-layer jobs require that big supports be manually added below every Short Sub part using Simplify3D's super-handy manual-supports feature of Simplify3D. Support for multi-layer prints using Makerbot slicers is still being worked on. Joints should rotate immediately after printing, though unusually stiff joints should be allowed to cool in order to reduce the chance of a peg shearing. A small tool head wiggled and wedged in between the corners of a main should all that's necessary to separate vertical layers of mesh. Larger meshes are constructed by using pegs to join a Main to a Sub. Note that the last few millimeters of one end of a peg has a slightly larger diameter in order to keep the peg seated in the Main. Snips can be used to trim the length of a peg if it sticks out further than desired. Have fun and please take the time to submit remixes for the benefit of all.