I recently "invested" in one of those tabletop studio things for shooting pretty pix of the things I post here and for customers. The sides of the photo booth are translucent plastic and allow ambient light to pass through. I found that I needed more control than that and purchased some gooseneck clip lamps however I did not have a convienent stand to clip them to so I designed this for the purpose. I suspect you can find other uses for this, including holding toilet paper rolls in the bath. I am using the new Philips led bulbs as well.I printed in PLA. 0.3mm
3 shells
15% fill You will need a mallet or small hammer to knock the "Brio"-style leg tabs into the base. The same for the other parts. if they fit a bit loose then I suggest you glue them.