Made for the D5100 camera. But will probably fit lot's of other Nikons. Just measure the naked viewfinder and if it is 24mm...ish across then this will probably fit. These things are just a simple cap to cover the viewfinder to stop ambient light from leaking trough the viewfinder. Good for those long exposures. I misplace or lose these all the time. It is just a simple piece of plastic so why fork out money for these when you have a printer?Just print flat laying down. No raft but with supports. I used 5 layers and 100% fill. This thing uses just a little over a gram of plastic, so no need to save on strength or weight, just make it solid. Use a sharp "x-acto" type knife for trimming away supports and adjusting the fit.