A Venusaur created to look like the Ken Sugimori art. This one would be hard to paint, so you might want to print it green (for the leaves) or pink (for the flower petals). Happy printing!This thing should be printed either upright or upside-down, to prevent the leaves and petals from falling off. Dissolvable support material is mandatory (other support material is difficult to remove from the petals, unless you scale this print up a lot). Minimum reasonable diameter for petals is 7.5 cm. If your layers are thin enough (e.g. 0.1 mm for 7.5 cm diameter), the leaves and petals should be reasonably sturdy.