These spinner covers is designed to fill the gap between the RVJET fuse and the spinner that comes in the RVJET power package. The cover has cooling outlet ducts to let cooling air out from the ESC and motor compartment. They are meant to be glued directly on the rear of the fuse. If needed there are some slots into which 3x1mm CF-strips can be used for reinforcements. An up-arrow shows how the cover should be aligned. Disclaimer: The cover is designed to be slightly smaller then the foam since foam can shrink depending on temperature and mechanical stress. In the renders you can see a slight edge but it should look better in real life. I have also not tried these from Shapeways myself but have printed using a FDM-printer. Please contact me if there is any questions and also please report back how well these fit and if any changes needs to be done to the design.OBSERVE: This was designed to fit the first RV power pack 3550 motor which was quite long. Because of this it might be too long for later versions of the power pack.