A flat SD card holder that clips onto the walls of your Rep2 without taking up much space.Designed to be quick to print, secure, easy to access and to maximize the visibility of the SD card label.Can attach anywhere on the outside of the Rep2, even upside down and it'll grip on. SD cards also gently wedge in at the bottom so cards won't fall out either.Updated version has a slight bend to the back lip to help grip better.Designed to be printed at 0.2mm. Walls are close enough together that you don't need infill. Images shown were printed with 1 shell, 0 infill, 0.2mm, sliced in MakerWare with Skeinforge. Prints in about 25 min with listed settings and default speeds.I suggest printing with clear or translucent PLA. Prints with 2 small flat circular supports to prevent curling, which are easy to rip off.