Securely connects the L-Com USB Surge Protector (now recommended for the FIRST Tech Challenge) to the NXT Brick. Uses zip ties and a few technic pieces. V6 - slight changes to ziptie holes to better align with technic pin holes and make the bracket slightly smaller V6 - slightly better alignment of A, B, C labels with motor ports The L-Com part is recommended on page 17 of this link: http://www.usfirst.org/sites/default/files/uploadedFiles/Robotics_Programs/FTC/Team_Resources/FTC_Robot_Wiring_Guide.pdf The L-Com part is at the link below: http://www.l-com.com/usb-usb-surge-protector-ecf-style-panel-mountable-type-a-type-b Prints flat with no support. Used 25% infill and it is still very sturdy.