Got a Dyson DC34 and a Swiffer Vac that you could rob the bottom off of? This might be for you. My Swiffer Vac had a dead battery pack and I had the DC34 before the DC35 came out. If you have the DC34, you know full well that it's meant for small areas and not do do floors; no attachment for it. Well... now there is! Works great too.Print the Vacuum End file, oriented so the large part is facing up. Heavy infill. I did 90% for strength. Print the Swiffer End pieces about 30-40% infill. Use supports with the inside facing upwards. Files should already be oriented that way. Materials Needed: -Length of 1" PVC pipe. Cut to desired length. -Two small course thread screws (sorry I don't have a size. Used what I had lying around) -Swiffer Vac bottom The PVC was slightly too small for the swiffer end pieces, but I went around it once with electrical tape and it fit very snug in the keepers. Sanding may be required to get it into the Vacuum end adapter as it was designed to be tight.