I wanted to hang a bunch of those Akro-like bins on my pegboard. Many of the hangers require that you screw the hanger into the pegboard. I wanted the flexibility of being able to move the hangers where and when I want to so I designed a bin hanger that accomplishes that. It is designed for pegboards with 1 inch spacing like those sold by Home Depot and other home improvement centers.Settings (Suggested) Raft: On Supports: On Infill: 35% Suggested to make sure 'pegs' are strong. Shells: 3 Layer Height: 0.20mm After printing,clean up and remove raft and supports with an xacto knife. Be careful not to damage pegs during cleaning. Don't forget to clean the pegs on the lower portion of the small supports. File as necessary for good fit in pegboard.