Because you want to carry your card games in style, I present to you, the Bang! Treasure Chest! :D It has been sized to carry the Bang card game with Gold Rush and Bang The Bullet expansion packs. It has hinges on the back like a regular treasure chest and clips on the front to hold it closed (no locks, I'm afraid). The box itself is thicker and sturdier than my previous design, but I reduced the overall length and height. You'll also need some super glue to attach the various decorations. Also, if like my hinge design you can download a more generic model here... http://www.thingiverse.com/thing:512044/Here are my thoughts on the various parts you'll need to print, none of which require support structures. It's all pretty self-explanatory, but just in case... Lid - This is the only difficult piece to print. Your printer needs to support bridges that can be up to two inches long (depends on how it was sliced). So I recommend printing this at a low resolution, like 0.4 mm. I managed without support structures on my printrbot. Top Inlay - This piece mostly snaps into place on the lid, but you may want to add some super glue. Just don't add any near the front clips, since that section needs to bend a little. Front and Back Inlays - Don't mix these up! They are different sizes. The front inlays are sized for the clip edges, and the back inlays are sized for the hinges. Front Clips - Super glue these onto the front of the top-inlay. Hinges - I recommend gluing the back inlays onto the box, then gluing the hinges into their slots between the box and the inlay.