I acquired a Fireball Island board, with no pieces. I wanted to put it back together, but doing so would be very expensive. I was inspired by spotzero's statue http://www.thingiverse.com/thing:293228 and by squar3d's figure http://www.thingiverse.com/thing:496388 (which actually prints fairly well as is). My TestIdol was going to take 5 hours, to print, so I made the mini version and printed it on the worst settings to get it in an hour last night. I will update this with newer/better versions as I finish them. UPDATE: 11/9/2014 - I added the triangle bridge. The one I printed was a smidge wide so I closed the distance up a couple mm on the model. Next will be the straight bridge and the idol updates. UPDATE 2: 11/9/2014 - I added the rectangle bridge. The one I printed's tab was a little short, but the added file is 5mm longer than the one I have. UPDATE: 11/11/2014 - I added a few more details to the idol. I'm still trying to figure out how to utilize the wrap feature in Solid Works better. UPDATE: 11/16/2014 - I printed a full-sized idol, but it is on 0.3mm layers and only good quality. It took 3 hours, I didn't have 9 hours for the best quality one. It works, so enjoy.