Print, and get metal loops to make into belts, necklaces, key chains, or other. Rather than metal loops, you could also just use any sort of thread to hold them :) I found the detail was difficult to print so made them lower profile I made the images using the method at http://lizquilty.com/2014/11/11/how-to-3d-print-from-an-image-conversion/ to convert the images to 3D printable objects, then plonked them onto the base i made. Should print at about 3cm each across. Main image is a beautiful print somebody else did shown here http://www.thingiverse.com/make:106496Print, and use however you want. I made the images using the method at http://lizquilty.com/2014/11/11/how-to-3d-print-from-an-image-conversion/ to convert the images to 3D printable objects, then plonked them onto the base i made. Should print at about 3cm each across. You may need to redrill the holes out a little, they are small and can close up with some printing