I produced this ornament to honor veterans during the holidays. So many of our Sailors, Soldiers, Airmen, Marines, and Coasties are overseas at the moment toiling for us. We should all keep them in our thoughts during this holiday season. Their are 4 F-22(s) in a "Missing Man" formation. I painstakingly designed each element of this ornament using Sketchup with many add ons (Solid Inspector, TTLib2, STL Export). I would not recommend designing in Sketchup if you access to a better CAD software I would recommend you use that. I found an engineering diagram online of the F-22. I imported it into Sketchup and traced all six sides of the engineering diagrams I then extruded and intersected the faces. I then cleaned up the faces and vertices. For the flag portion of the ornament I used Sketchup, the union jack and red stripes are offset by 0.2mm to slide in to place.F-22: (Print these one at a time, they are delecate) Supports On 0.1mm Layer Height 30% Fill 1 Shell All the other STL(s): Supports Off 0.3mm Layer Height 20% Fill 2 Shells Clean off the excess of the 4 prints using an exacto knife. When you are finished your print should be able to fit a piece of 1.75mm filament in the mount hole on the underside of the jet.