My new Potter Project for a Laser Diode 2W 445nm with cpu heatsink bracket Have again a little time for the nights project drawn in my ViaCAD yesterday and today toothbelt wave 5mm / ball bearing 13mm / 5mm / 4mm the rear holder Y axis 8mm rod,+ Lm8uu X slide ball bearings are 8mm / 3mm / 3mm ,and the rod 6mm Z axe 5mm threaded rods and 5mm Rods with the 5mm Rods, I use PA6 or Teflon plain the Z warehousing I have to self-clamping made where there 35mm x10mm be used gliders. The X axis have for 6mm rod fixing holder have made the bohr holes 2.3mm, and the'll stick directly with superglue on because 20x20x1.5 aluminum profile with 2.3mm drill then drill through and provided with m3 thread. later I'll start at the parts to print. Perhaps the idea is also interesting mfg ;) a couple things I have now printed. rest because I print tomorrow. and on weekends, when is time again is all built together Ups've had in 3 stl files error fix motor1plate.stl fix plottiea.stl fix zbeltclamp.stl Yesterday I screwed a few things together. 6mm fixable holders should be carefully rework on the weekend I started to build the housing, and because screwed pottie frame. Front right is a control panel for laser control, will first be pro forma, later came to lcd + SD. Tooth belt and toothed belt wheel take from Helicopter T-rex 450, And extends with fishing line, "there was Will try it in my penultimate project". because at small T-rex 450 tooth belt wheel "6.2mm Druchmesser" should I get about 120 steps per mm. Since the waves are 3mm, I have to build adapter in my lathe. Last weekend, I have unfortunately done much. New Z axis with plain bearing sintered bronze 5x9x8. 5mm shafts pieces I've turned down to about 3:08 /3.10mm and the toothed belt wheels pressed pure. X axe timing belt attachment on the left/right "beltbb and beltcc" both are simply provided with cable ties. with a small adjustment range. And am now almost finished, here comes yet the housing drann with smoke extraction system and so, and then the electronics.