Used for Flames of War; modular bocage/hedgerow; These are a (big fat) work in progress; they can take a little while to print; printed with very minimal support along the outer areas; use a length of filament to connect them together end to end or glue as needed. They are about 3-4 inches in length; they can scale up a little larger if needed. This is a mash-up of the vines, bloxen bramble and virus/proteosome model; I've also used the virus/proteosome models as smoke plumes in the past, if printed at the right scale and dry-brushed they look just about right. I need to finish the bottom rubble base and some entry gates and possibly a t-section/angled-section. The rubble base isn't needed but adds a little height; The bottom rubble would be printed separately in black ABS and the bocage would be printed in green ABS followed up with some variations of brown/green paint colors. Will probably play around with some polygon reduction to reduce the size and print time. Paint as needed, use of flock isn't necessary but can soften the features. I based this somewhat on the OOP hedges from Miniature Building Authority; as seen on Ben's RPG Pile Hedge Maze Episode - https://www.youtube.com/watch?v=ksvS0N9Chy8