This was designed as a gift for a very special couple. I originally designed the plaque to be hung in a window, but later decided to make it bottom edge lit with LED's. The LED light string is one that is readily available and inexpensive. The base is designed to hold a 3mm thick, 3" X 5" acrylic etching. The plaque is a cut at 3"x5". By changing the quoted text, this can be used for many different occasions and/or awards. Using the CDR file, etch and cut the plaque. Print the base pieces. Mine were printed at .2/layer in PLA. The holed strip is to hold the prewired LED's. I used hot glue to hold them in place. The place the LED strip into the base with the LED's facing toward the narrow slit. I purchase my lights from http://www.lightsforalloccasions.com, but they can be found in most hobby shops if you are not up for making your own. I keep a supply on hand for making wine bottle lamps. I then hot glued the lamp bar inside of the base to keep it secure. Slide the 3X5 Plaque into the top and turn on the LEDs