** also check out my latest design: http://www.thingiverse.com/thing:1078661This is a remake of my other "Small Vise V1" http://www.thingiverse.com/thing:624091 . The base now consists of one solid part, and the slider can be placed in the grooves trough the top of the base. I also removed the feet since some people didn't like them. (requires less parts aswell). Please take the time to upload a photo of your thing! =)Base and Slider printed with 20% infill and 2 walls. knob was printed 100% for little more strengt. Parts needed: 1 M8 bolt rod about 120 mm long (5/16 inch, 4,5 inch long) 3 M8 hex nut's (5/16 inch) Insert the m8 nuts where they belong, use a solder iron to heat the nuts so that they melt in place and stay locked. Have fun!