This wire box is derived from the flat box for RAMPS designed by Yvan. My idea is to create a similar box below the RAMPS box that houses all of the cables and has access on the left and right sides. I am simply inverting the box ( flipping it upside down ) and using sides that have cable chain connector holes. For the Female connection, simply insert a regular chain link, with the male side from out of the box to inside, then superglue the connector in place. The Original Cable Chain this is remixed from is http://www.thingiverse.com/thing:11978 Left side: Cable tie holes on the left of the part, Cable chain connection at the bottom of the part. Right side Cable tie holes on the right of the part, Cable chain connection at the bottom of the part. Bottom: Back Plate: (drill your own holes based upon your frame design) Door: Use 4 cable ties to attach door Super glue all parts except the door together Designed to house all wires leaving an opening to the open bottom of the RAMPS case. Door not required to open as just housing cables, so is closed by cable ties and if you need to go into it cut then replace cable ties.
- 0 inches x 0 inches x 0 inches
- this product is 3D printed
- 16 available colors
- material is a strong plastic
- free delivery by May 06
- 0 parts