---ADDED Vase10A. Somewhat different. I accidentally turned on spiral single wall mode on the first print of 10A. The photo is a testament to the quality of Gizmo Dorks Transparent 3mm ABS! I did manually slow from 100% to 65% when the open spiral layers started. This was printed fast with .33mm layers. New design I did not want to include with Turbo-Vase+, but it is from the same clan. This one is not just a straight tube for the vase holder. I actually has a cavity that follows the lower bulb. It not only saves time and material, but is capable of collecting more dust! I am including the sliced vase so you can see the interior, but I would not recommend trying to print it. When I sliced this with Simplify3D some walls near the top were dropped apparently because they are very thin. I gives a great effect that cannot be seen here. I gives me inspiration for the next iteration. I will post a photo so you can see what i am talking about when the print is complete.