Simple handbrake mount for the G27/G25 shifterNeeded to complete: 1x limit switch 2x 1/4-20 1in bolt 1x 1/4-20 2in bolt 4x 1/4-20 nuts Glue Some wire Soldering skill 1in PVC however long you want Solder locations are shown in the pictures. Glue the wires to the board to relieve stress on the solder joints. Be very careful not to pull on the wires after you solder them because it is very easy to rip the connection off the board, and break the button. Use the base as a template to drill the holes, and then cut out the small notch for the wires. Attach the base with the 2 1 in screws and nuts, then glue the nuts in place. Re-assemble the shifter and attach the PVC to the base by drilling a hole straight through, and using the 2in bolt and 2 nuts to secure it to the base. You can use the included spacer in between the PVC and the base to make the handle more stable. You can also glue the 2 nuts onto the base. Glue the Hook onto the side of the base, and put the rubber band on. For more detailed instructions on the soldering and disassembly, check out this video: https://www.youtube.com/watch?v=scQ8-uSq01E
- 0 inches x 0 inches x 0 inches
- this product is 3D printed
- 16 available colors
- material is a strong plastic
- free delivery by May 09
- 0 parts