Dihedral tilt top for the RCExplorer tricopter V3. Experimental! For use when cutting the arms in half and building a mini tricopter. Derivative of David Windeståls excellent work. Get the frame and necessary servo at http://www.rcexplorer.se/shop. Use M3x35 hex and a washer for the tilt mechanism (original was M3x40) (For the servo horn version, use M3 locknut and M3x30 hex screw) Use M3x20 hex screws for the front legs. Use two M3x6 hex screws for the tilt. Use two M3x20 for the rear leg Use two M3 locknuts for the tilt bottom Two kinds: NTM style hole pattern and Elite style hole pattern (rotated 90 degrees) Hole spacing 19mm. I did a small test of the functionality of the dihedral tilt mechanism here: http://youtu.be/oGvY1ehM_Vs Buy the original tilt mechanism from RCExplorer.se (http://rcexplorer.se/product/tricopter-tilt-mechanism-3d-printed/) or download the STLs: http://rcexplorer.se/downloads/Print the tilt top, tilt bottom, servo holder and mount tops solid, preferably 0.1 layer height. Print the legs to suit your needs, lightest build would be 15% infill, 0.2 layer height.