February 16, 2015 After printing and fitting the V2 on my MHQ2 I realized that while the landing gear works fine with the angled part facing out it hits one of the frame supports if you turn it around. Shaved off 1.8mm from the base to make it fit either way. Update Feb 13, 2015 - After printing my first set I realized that I put the bolt holes in the wrong place. Corrected and uploaded a new STL. Also added V2 with a 10mm wider base as well as correcting a few drawing errors. I needed some landing gear that would accomodate an XT60 Plug and still have a flat surface to mount an LED strip to for some running lights for racing. Didn't find what I needed so I tried my hand at building one myself. Not the fanciest thing out there but it should do the job. Thought i'd share.