This is a drafting tool that enables you to place 11 equally spaced points along a line, creating 10 equal length segments. These tools are typically made out of stainless steel with riveted pins and cost upwards of $200. This version will get the job done for a fraction of the cost!To construct a ten point divider of your own, start by printing out all of the pieces in your desired colors. If a quantity is indicated in the part file name, then print that number of multiples (e.g. "7x" means print 7 of them), otherwise only print one. Assemble the divider by inserting "LinkPin" components into the holes and glue the "Plug" component on into the holes with epoxy or super-glue. Be careful not to get glue in the joint!