All the 3D printed parts needed to make a RCExplorer V3 inspired mini tricopter. This work is heavily based on David Windeståls brilliant design and work. Please support David by getting the missing parts off his website: rcexplorer.se/shop. You can even buy the full size frame and just cut the arms to length. Use ten M3x20 hex for the frame Use ten M3 lock nuts Use one M3x35 for the tilt mechanism Use Afro 20A slim ESCs Use Multistar Elite 2204 2300Kv for motors Use 6x3" gemfan carbon props Use Flip32+ flight controller Use 6+ channel radio Use 3S up to 2200mAh lipo Use 18AWG wiring Use a Blue Bird – BMS-210DMH Servo for the tilt mechanism Use 160x10x10mm woven carbon fiber booms - (Cut these in half http://rcexplorer.se/product/10x10mm-woven-carbon-fiber-arm/) Use 1.5mm pianowire for dampening wires (http://rcexplorer.se/product/pre-bent-vibration-dampening-wire/) Get RCExplorer.se power distribution board integrated into the frame once it gets available! Learn how to assemble a tricopter from the King of Tricopters! http://youtu.be/kvZGA6dJQJs Sample footage:http://youtu.be/oGvY1ehM_Vs