Apple does not sell a dock for the iPhone 5 so I made one for myself. This is meant to be cut out of 1/4" Acrylic and bolted together with a standard iPhone 5 charging cable stuck in it.Note: The SVG was created in Inkscape. I did this on my Full Spectrum 40W Laser in 2 steps. Step 1) Engrave the Black areas in the SVG slow and deep. I used a speed of 25% and 100% power. I ran the engraving twice. Step 2) Vector cut the red. Next assemble the plates. The holes are sized for 3mm x 35mm cap head screws. If you counter sink the holes on the bottom plate, the 35mm screws fit perfectly. The order of the plates from bottom to top: SVG Row 1) 4, 5, Top(6) SVG Row 2) Bottom (1), 2, 3