Nanode - A Network Application Node.Nanode is like an Arduino but with ethernet/web connectivity.It also supports easy to use wireless and wired networks. It has been developed as a low cost tool to allow simple sensor networks to be developed. It's the perfect platform for smart sensors, home automation, monitoring and control.It's through hole construction and the use of socketed DIP ICs makes it easy to build for the home constructor.It's been competetively priced so that it costs about the same as an Arduino (roughly $30 US, or £18).Without the ethernet parts it's sub $20 and can be used as a low cost Arduino "work-alike". It's compatible with most Arduino shields.It has some key advantages over the basic Arduino:This is the productionised version of the Nanode for the London Hackspace. It's very much updated and includes a whole lot of new features.SPI serial memory either SRAM, FRAM or EE for storing data and web pages,Microchip MAC chip so that it has a unique MAC address.4.Moves the reset switch to where you can get at it - side actuated6.Improved connector for local power/comms bus with 4 pin screw terminal block. Makes for simple interconnection with 4 way telephone cable.Adds the London Hackspace Logo, Pachube Logo and Arbour Wood Ltd details.Adds Auto-reset (from FTDI cable).EagleCAD schematic and board files included enable this board to be made by pcb fab-house.Zipped Gerbers also includedSee the Project Wiki Page on the London Hackspace site for more information about this version.http://wiki.hackspace.org.uk/wiki/Project:Nanode