A simple organizer for the GoPro HERO4 dual-battery charging station with slots for additional batteries and SD cards. The floor of each slot is raised so that the equipment height is even across the top. The battery charger can be used while stored and the cutout for the USB jack is over-sized to allow for most cables.My print was done at 300 microns in ABS, support material in place for the USB cutout, three perimeter layers, four upper and lower surface layers, and 15% infill. The slots for the batteries and SD cards were sized very slightly larger than necessary (0.5mm) to insure that they would not be too tight when the print cooled and contracted. When flipped over, the SD cards will fall out, but the batteries and charger are just snug enough to stick.