After countless failures caused by my hand built kinect connector I designed and printed this. For now it works perfectly but I might improve the design some more.As some are a bit confused this is for connecting the Kinect to another device like a PC. The Kinect that comes with an Xbox has a nonstandard connector that has a rather odd spacing. This fits right into the special proprietary connector on the Kinect and allows you to interface with a standard 12V and USB.If you don't have access to a good enough printer just drop me a message see if I can send you one.Just use wire to fill in the gaps left in the connector.The "blunt" end goes in first. DON'T insert this upside down if it's powered! There's no protection against this human error. I am not responsible for ruining your equipment.