Mendel90 EZStruder LM10UU X Carriage. Download and print this if you want to use an EZStruder with an LM10UU Mendel90. Original printer design by user 'nophead' at http://www.thingiverse.com/thing:17826 ezmount_fixed.stl was borrowed from user 'goopyplastic' at https://www.thingiverse.com/thing:151551 NOTE: Depending on the depth of your extruder motor, it may be possible for the motor to touch the inside edge of the gantry (left side only). However, this only happens after you have exceeded the useable print area of the bed, so this should never happened under normal operation. I simply placed a strip of adhesive foam to the rear/left surface of the motor to act as a soft bumper in case contact was ever made.