Up late at night and decided I'd use some of my time to design a little kayak! Me personally, I love to kayak, breaking those glassy waters of a river is INSPIRING! Print is made into TWO files. One for paddles, the other for the kayak itself. Multi-color maybe???????? ;) MAKEITFLOAT: Length (bow to stern):175mm / 6.88976Inches Width (at waist): 40mm / 1.5748Inches Weight:21.4g Maximum carrying weight +30g Total weight when maxed 51.4g (weight of paddle .5g) The kayak can carry 1.4 times its own weight. Maximum Capacity: 5 Quarters (1.25) USD) OR 6 Nickels (0.35 USD) OR 11 Pennies (0.11 USD) OR 13 Dimes (1.30 USD) If the weight of the object is < the buoyant force the object will float If the weight of the object is > the buoyant force the object will sink If the weight of the object is = the buoyant force the object will experience equilibrium The deeper an object is submerged, the greater the pressure is. Which means that the pressure on the bottom of the object, in this case a kayak, is greater than the pressure above the surface of the water. In short, pushing the boat up towards the surface. According to Archimedes’ Principle, the buoyant force is equal to the weight of the fluid displaced by an object, once again in our case, the kayak. The density of the PLA (polylactic acid) is 1,210–1,430 kg/m3 The density of Water (H2O) is 999.97 kg/m³ This means that a SOLID centimeter cube of PLA would SINK in a bowl of water. So in order to counteract that, Need to make the density of the BOAT lower than the density of the water. Of course the USA sticker helps it float too! GREATNESS RISES!First, prepare the "Kayak.stl" file. Second, prepare the "Paddles.stl" file. Finally, print & enjoy! Maybe have the paddles one color and the kayak another?? Ideas man.. Ideas.